Details

---

Description 

Novoplan 21 is used for levelling and smoothing new or existing substrates and provides an underlayment for receiving PVC, linoleum, rubber, cork, textile and non-woven flooring in areas where a good resistance to loads and traffic in of fices and public areas is required. Novoplan 21 must only be used in interior conditions in thicknesses from 1 to 5 mm. 

  

Applications 

• Smoothing of concrete slabs and cement-based screeds or Topcem, Topcem Pronto, Mapecem or Mapecem Pronto screeds.. 
• Smoothing of anhydrite screeds.. 
• Smoothing of under-floor heating installations.. 
• Smoothing over existing ceramic tile, terrazzo, natural stone and magnesite floors.. 
• Technical Data Sheet (T.D.S). 

  

Recommendation 

• Do not add more water to the mix once it has begun to set.. 
• Do not add lime, cement or gypsum to the mix.. 
• Do not use for smoothing in exterior s or for substrates subject to rising damp.. 
• Do not apply another coat of Novoplan 21, once the previous one has dried completely, without first applying diluted Primer G (1 part by weight of Primer G diluted with 3 parts water).. 
• Do not use Novoplan 21 at temperatures below +5°C or above +35°C.. 
• Not suitable for installing wood and par quet floor and wall coverings.. 
• Do not apply Novoplan 21 in thicknesses less than 1 mm.. 
• Do not use for levelling over wooden substrates.. 

  

Technical Data (Typical Values) 

Product Identity
Consistency	Fine Powder
Colour	Grey
Bulk density (kg/m³)	1200
Dry solid content (%)	100
Storage	12 months in a dry place in original packing
Hazard classification according to EC 1999/45	Irritant..  Before using refer to the “Safety instructions for.  preparation and application” paragraph and the  information on the packaging and Safety Data Sheet
Customs class	3824 50 90
Application Data (at +23ºC and 50% R.H)
Mixing Ratio	approximately 25-26 parts water for 100 parts by weight of Novoplan 21
Thickness per coat (mm)	from 1 to 5
Self-levelling	good
Density of mix with water (kg/m3)	2000
pH of mix	aprrox. 12
Application temperature range	From +5°C to +30°C
Pot Life	Approx. 20-30 minutes
Setting Time	Approx. 50-70 minutes
Set to light foot traffic	3-4 hours
Waiting time before bonding	24 hours
Final Performance
Compressive strength (EN 196) (N/mm2):  – after 28 days:	22.0
Flexural strength (EN 196) (N/mm2):  – after 28 days:	7.0
Resistance to abrasion-weight loss (with Taber abrasion meter, H22 disk, weight 550 g after 200 rev.):  – after 28 days curing:	3.5g

  

Packaging 

• 25 kg/bag. 

  

Storage 

• 12 months in a dry place and unopened packing. 

  . 

  

Consumption 

• 1.6 kg/m2 per mm of thickness. 

  .