Details

---

• As some solid matter in webermix GT mix I may settle during storage, it is essential to stir well before use in temperature lower than 4°C

• Allow adhesive bed to set, usually 24 – 48 hours before grouting commences. Joints must be dry and free of contaminants ie. Loose particles, dust, laitance etc

• webermix GT mix I is ready to use; therefore does not require further addition of water

• Cement-based grout modified with webermix GT mix I, should be applied in the normal approved procedure (similar as when mixed with water only)

• Apply grout to small areas at a time & completely fill the joints with a rubber squeegee or grout float

• The working time (pot life) of grout modified with webermix GT mix I may be reduced slightly. The drying time may also be shorter, particularly where higher concentration of admixture is used.

• The finish colour shade of cement-based grout mix with water may not be similar compared to those mixed with webermix GT mix I.

• For uniform colour, ensure that the same mix proportions is used throughout the installation